Default Usage Alerts

Usage Alerts determine when you get notified about a leak. Flume creates two Usage Alerts when you first install your device.  

These rules can be turned on, turned off and/or modified. You can even add your own leak rules. First, let's take a look at the two default leak rules:

Low Flow Leak

We find that the majority of leaks are "low flow". Running toilets, slab leaks, pinhole leaks, etc. all fall into this category. Basically, this "low flow" leak rule will notify you if water is running constantly for a long period of time. In other words, your water usage never goes back to zero. By default, this rule is turned on, and it will let you know if water is running constantly for two hours. 

There is a new toggle for "advanced low flow leak detection" - when this is on it will filter out likely irrigation events from leak detection. So for example if you have a rule set to trigger if water is running for two hours, but your irrigation runs for three hours the rule will no longer trigger.

To turn on Advanced Low-Flow Detection, just depress the slider until it turns green. To turn a Leak Rule off, depress the slider until it turns white. 

To view default settings of the Low Flow Leak notification, click on Low Flow Leak from Leak Rules screen. Default settings can be adjusted as necessary. See Editing Leak Rules below.

High Flow Leak

High flow leaks are rare but they can cause a lot of damage in a short period of time. By default, this leak rule is turned off. If you turn this rule on, you may get some false leak notifications if you have anything in your house that uses more than 5 gal/min for a period of 15 minutes. If this is the case, you may want to monitor your water usage in the Flume app to see what your peak water usage is per minute. You can then bump up the flow rate to something more appropriate. 

To view default settings for High Flow Leak notifications, click on High Flow Leak from the Usage Alerts screen. Default settings can be adjusted as necessary based on your water usage.

Turning Leak Rules On and Off

In the screenshot at the top, you see a slider next to each Leak Rule. To turn a Leak Rule on, just depress the slider until it turns green. To turn a Leak Rule off, depress the slider until it turns white. 

Editing Leak Rules

To edit a leak rule, just click on the leak rule that you want to edit. 

For instance, let's say that you never run water constantly for more than an hour at a time. In this case, you may want to make your Low Flow Leak Rule more strict. To edit this rule, simply click on it, and you will see a screen that looks like this:

To continue our example, we would then change the "Leak Duration" to "1 hour" and click "Save". 

Adding New Usage Alerts

To add a new leak rule, simply click on the "+" sign at the top of the page.

Away Mode Rule Setup

If you are leaving your house, and you don't expect to be using any water while you are gone, you may want to set up a rule for Away Mode. This will notify you if any water is running for more than a couple of minutes. This could be very useful for vacation homes. Below is a good criteria to use for Away Mode.

Did this answer your question?